Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 122)

122 K2 Media Client Service Manual June 25, 2009
Chapter 5 Removing and replacing FRUs
SCSI interface board removal
To remove the SCSI interface board, first remove the top cover and the front panel,
then proceed as illustrated.
Refer to “SCSI controller adapter removal” on page 137 for cable detail on RAID
controller adapter to identify SCSI 0 and SCSI 1 cables.
2 Remove SCSI 1
cable*
3
Remove power
distribution cables
1 Remove SCSI 0
cable*
Trace SCSI cables to
RAID controller adapter
to identify. These cables
not present on systems
with no SCSI backplane. *
The motherboard cable is not
present on older versions of
the SCSI interface board * *
6 Remove fan
power cable
5 Remove USB
cable
4 Remove motherboard
cable**
7 Remove six screws
8 Disengage from
backplane, if present
9 Slide out through
front