Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 125)

June 25, 2009 K2 Media Client Service Manual 125
Codec board removal
installing the replacement board, make sure screws are installed in the proper
sequence, as illustrated:
Loosely install
center screw 3
Install side
screws tightly 4
Tighten
center
screw 5
Install side
screws
6
Install side
screws 6
Install center
rear screw 7
Connect large
power cable
On HD-00 models,
also connect
small power cable
8
Carefully engage the
RTP board 2
Move board into position,
then reach under and
connect XLR board cable 1