Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 90)

90 K2 Media Client Service Manual June 25, 2009
Chapter 3 Service Procedures
The Restore Operation option page opens.
15. Do not make any selections. Click Next .
The “…ready to proceed…” page opens.
16. Verify that you are restoring partitions. Click Proceed .
The Operation Progress page opens and displays progress.
17. Insert CDs as prompted. As messages appear asking for disks, insert CDs
sequentially and click Retry .
18. When a “The data was successfully restored” message appears, click OK .
19. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
20. Remove the Recovery CD while the machine is shutting down.
Activating the Windows operating system
If a K2 Media Client is restored to its factory default state or otherwise has the
Windows operating system re-applied, you might need to activate the operating
system. This procedure provides instructions for doing this while the machine is
connected to the Internet. The Activation wizard provides other options, which you
can also choose if desired.
To activate the Windows operating system on a K2 device, do the following:
1. Make sure the machine is connected to the Internet.
2. From the Windows desktop, in the system tray double-click on the key symbol
icon. The Activate window opens.
3. Select Yes, let's activate Windows over the Internet now and click Next .
4. When prompted, “If you want to register with Microsoft right now.”, select No .
5. Wait for the connection. If the system times out, you are prompted for entering
information in the Internet Protocol Connection dialog. Enter the proxy address
and port number as appropriate for your facility’s connections.
6. Ensure that “You have successfully activated your copy of Windows” message
appears in Activate Windows.
7. Click OK to close the Activate Windows.
Installing the Fibre Channel card driver
If the K2 Media Client has the Fibre Channel option and you restore from the generic
disk image, the Fibre Channel card driver is not on the disk image. After restoring the
disk image, you must install the Fibre Channel card driver as instructed in this
procedure.
1. Make sure that you have access to the Fibre Channel card driver file. On the local
K2 Media Client, look for C:\profile\drivers\LSI_SCSIPORT_1.21.25.00, then do
one of the following:
• If the file is present, continue with the next step in this procedure.