Grass Valley 3400 CopperHead - Manual (Page 91)

85
Base Station Connectors
Base Station Connectors
Reference Numbers refer to the Overview Diagrams at the end of this User Guide.
Item Description
AC Power Input Connector‐ Models CHG3‐BS‐3400‐95VD‐xxx‐xxx
Base Station #1
Standard IEC C14 receptacle
Panel Mounted AC Power Receptacle: 110/220 VAC
Two 4 amp fuses (5 x 20mm).fuses are in operation at all
times – both the AC Line Hot and the AC Line Neutral
are fused.
12VDC Input Power Connectors – Models CHG3‐BS‐3400‐2ST/2MX/NEU
Base Station #20
XLR4 Male
• Pin 1: Ground
• Pin 2: Unused
• Pin 3: Unused
• Pin 4: + Power 12 VDC
This matching connector is from either an ADAP-AC-04
or a customer-supplied 12VDC power supply
This connector is wired in parallel with terminal block
#21 (below)
Base Station #21
Terminal block
• Pin 1: Minus Voltage Terminal
• Pin 2: Plus Voltage Terminal
This connector is wired in parallel with XLR4 Male #20
(above).
95VDC output: Model CHG3‐BS‐3400‐95VD‐STM‐xxx
Base Station #23
Mating connector:
Molex 39-01-4051
• Pin 1: 95VDC + OUT (White*)
• Pin 2: 95VDC + OUT (Black*)
• Pin 5: Ground (Green)
*Tied together at terminal lug end
Base Remote
Base Station #9
DB9 Female
Format select (Pin 2)
Floating for RS-422 or TTL
Tie to GND (pin 3) for RS-232
Tie to +12VDC (pin 4) for RS-485
• Pin 1: Data 1 -422 In, -485 I/O
• Pin 2: Data 1 Format Select
• Pin 3: GND (Ground)
• Pin 4: +12 VDC Bias for Data 1 Format Select
• Pin 5: Data 1 -422 Out
• Pin 6: Data 1 232 In, +422 In, +485 I/O
• Pin 7: - 12 VDC Camera Control Data Power Ground
• Pin 8: +12 VDC Camera Control Data Power
• Pin 9: Data 1 232 Out, +422 Out
Please See
Available Accessories on page 96 for a list of
Grass Valley, a Belden Brand supplied cables.