Grass Valley 3400 CopperHead - Manual (Page 23)

17
CopperHead 3400
User Guide
Fig. 3-5: Camera Unit Indicator Panel LEDs (2)
• 4 - Data Signal Path Monitors CCU and Data 2: Data 2 is typically used for auxiliary
devices such as Robotic Pan & Tilt Head:
• CCU – used for Camera Control Unit
• Data 1 – used for a serial control device (RS232, 422, 485)
• Data 2 – typically used for auxiliary devices such as Robotic Pan & Tilt Head
• Data 3 – used for a serial control device (RS232, 422, 485)
• 5 - TC – Time Code Signal: Monitors Time Code to Base Station and return from Camera
• 6 - Ethernet Signal: monitors Ethernet to Base Station and return from Camera
• 7 - GPI/Tally Signals 2: monitors GPI/Tally Signal to Base Station and return from
Camera and GPI/Tally Signal 2 to Camera Unit
• 8 - Tally 1 Light: lights up RED when GPI/Tally 1 signal is activated at the Base Stations
• Off when the signal is not present
• On when the signal is present
For information about configuring the use of Tally in your system, see Multi-Pin Connectors:
Suggested Wiring on page 92.