Grass Valley 3400 CopperHead User Manual
Page 63
57
CopperHead 3400
User Guide
Diagram #
Description
8
Data Connector
Multi-Pin Connector B – DB15 15 Pin Serial Connector. This carries serial
control signals for lens and remote pan & tilt units as well as GPI, Intercom
Trigger (GPI) and Tally signals. Grass Valley supplies a number of pre-
configured break out cables for use with this connector.
Available Accessories – Cable Numbers
9
3D/Dual Link Inputs
BNC Connectors – Carries 3D/Dual Link camera video from the Camera(s) to
the Camera Unit. This requires BNC jumper cables between the Camera Unit
and the Camera (s).
10
HD-SD/SDI Input
BNC Connector – Carries camera video from the Camera to the Camera Unit.
This requires a short BNC jumper cable between the Camera Unit and the
Camera.
11
HD-SD/SDI Outputs #1 & #2
BNC Connector – Carries return video from the Base Station to the Camera
Unit. Typically this will feed a camera viewfinder or an HD viewing monitor
at the camera location.
12
VBS In
BNC Connector – Carries SD Analog video from the Camera to the Camera
Unit. This requires a short BNC jumper cable between the Camera Unit and
the Camera. Can be used to provide technical monitoring from camera as
with superimposed camera menus and other information.
13
VBS Out
BNC Connector – Carries SD Analog video from the Base Station the Camera
Unit. This feeds an analog monitor at the camera location.
14
Ethernet Out
RJ45 Connector – Carries IP Data. Typically connects to a Laptop computer
or perhaps a wireless access point at the camera location. Any IP traffic
controlled equipment can be handled through this signal path.
15
Power Wafer Connector
Multi-Pin Connector C – Supplies power to the Camera Unit from the Power
Wafer (if so configured). This cable is supplied with the Power Wafer Power
Adaptor.
16
Fiber Connector
Swivel Mounted Fiber Optic Cable receptacle – specific connector depends
on your configuration.
22
Intercom Headset Connector
Mini-phone Jack – Provides listen only Intercom audio.