Safety information, Optical fiber safety power fuses, Optical fiber safety – Grass Valley 3400 CopperHead User Manual
Page 10: Power fuses
4
Introduction
Safety Information
Safety Information
Optical Fiber Safety
To prevent eye damage, never look directly into the end of the optic fiber while either end
of the system is operating.
Always use cable connector caps when the cables are not connected. This protects the
connector from damage and the unlikely event of exposure to an operating optical link.
Keeping the caps in place when the connectors are not in use will prevent dirt and dust
from entering the connector and degrading the performance of the optical link.
Power Fuses
The CopperHead 3400 Base Station with internal power is equipped with Dual Cartridge
fuses located next to the AC Power receptacle at the left rear of the unit. Refer to
on page 85 for specific location information.
NEVER operate the CopperHead 3400 Base Station without properly installed and rated
fuses. Severe electrical and heat damage could result as well as personal injury or death.
The fuses supplied are standard 4 Ampere fuses – 5 x 20mm. Both fuses are in operation at
all times – both the AC Line Hot and the AC Line Neutral are fused.