Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 89

78
Configuration procedure
NOTE:
•
Before performing the following configuration, make sure that the device and the host are accessible to
each another via available routes, and the IP addresses of the interfaces are configured as shown
•
This configuration may vary with different DNS servers. The following configuration is performed on a
Windows server 2000 PC.
1.
Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
, right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.
Figure 32 Create a zone
# Create a mapping between host name and IP address.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points