beautypg.com

Configuring ripng route redistribution, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 187

background image

176

via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec

Peer FE80::20F:E2FF:FE00:100 on Vlan-interface200

Dest 4::/64,

via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec

Dest 5::/64,

via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec

[SwitchA] display ripng 1 route

Route Flags: A - Aging, S - Suppressed, G - Garbage-collect

----------------------------------------------------------------

Peer FE80::20F:E2FF:FE00:1235 on Vlan-interface100

Dest 1::/64,

via FE80::20F:E2FF:FE00:1235, cost 1, tag 0, A, 2 Sec

Dest 4::/64,

via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec

Dest 5::/64,

via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec

Configuring RIPng route redistribution

Network requirements

Two RIPng processes are running on Switch B, which communicates with Switch A through RIPng

100 and with Switch C through RIPng 200.

Configure route redistribution on Switch B, letting the two RIPng processes redistribute routes from
each other. Set the default cost of redistributed routes from RIPng 200 to 3.

Figure 62 Network diagram for RIPng route redistribution configuration

Configuration procedure

1.

Configure IPv6 addresses for the interfaces (omitted)

2.

Configure RIPng basic functions

# Enable RIPng 100 on Switch A.

system-view

[SwitchA] ripng 100

[SwitchA-ripng-100] quit

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ripng 100 enable

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 200

[SwitchA-Vlan-interface200] ripng 100 enable