H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 169)

158
Displaying and maintaining RIP
To do… Use the command… Remarks
Display RIP current status and
configuration information display rip [ process-id ] [ | { begin | exclude |
include } regular-expression ]
Available in any
view
Display all active routes in RIP
database display rip process-id database [ | { begin |
exclude | include } regular-expression ]
Display RIP interface information
display rip process-id interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Display routing information about
a specified RIP process
display rip process-id route [ ip-address { mask |
mask-length } | peer ip-address | statistics ] [ |
{ begin | exclude | include } regular-expression ]
Reset a RIP process reset rip process-id process
Available in user
view
Clear the statistics of a RIP process reset rip process-id statistics
RIP configuration examples
Configuring RIP version
Network requirements
As shown in Figure 55 , enable RIPv2 on all interfaces on Switch A and Switch B.
Figure 55 Network diagram for RIP version configuration
Configuration procedure
1. Configure an IP address for each interface (omitted)
2. Configure basic RIP functions
# Configure Switch A.
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0
# Configure Switch B.
[SwitchB] rip
[SwitchB-rip-1] network 192.168.1.0
[SwitchB-rip-1] network 10.0.0.0