Route oscillation occurred – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 175

164
If the peer is configured to send multicast messages, the same should be configured on the local end.
Solution:
•
Use the display current-configuration command to check RIP configuration
•
Use the display rip command to check whether an interface is disabled
Route oscillation occurred
Symptom:
When all links work properly, route oscillation occurs on the RIP network. After displaying the routing
table, you might find some routes intermittently appear and disappear in the routing table.
Analysis:
In the RIP network, make sure that all the same timers within the entire network are identical and have
logical relationships between them. For example, the timeout timer value should be greater than the
update timer value.
Solution:
•
Use the display rip command to check the configuration of RIP timers
•
Use the timers command to adjust timers properly.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points