Configuration procedure, N in, Figure 43 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 110
99
Figure 43 Network diagram for UDP helper configuration
Configuration procedure
NOTE:
Make sure that a route from Switch A to the subnet 10.2.0.0/16 is available.
# Enable Switch A to receive directed broadcasts.
[SwitchA] ip forward-broadcast
# Enable UDP helper.
[SwitchA] udp-helper enable
# Enable the forwarding broadcast packets with the UDP destination port 55.
[SwitchA] udp-helper port 55
# Specify the destination server 10.2.1.1 on VLAN-interface 1.
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ip address 10.110.1.1 16
[SwitchA-Vlan-interface1] udp-helper server 10.2.1.1
IP network
Vlan-int1
10.110.1.1/16
Vlan-int1
10.2.1.1/16
Switch A
Switch B
Server
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points