H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 181)

170
To do… Use the command… Remarks
Enter interface view
interface interface-type
interface-number
––
Advertise a default route
ripng default-route { only |
originate } [ cost cost ] Required
Not advertised by default
NOTE:
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
Configuring a RIPng route filtering policy
You can reference a configured IPv6 ACL or prefix list to filter received/advertised routing information.
You can also specify a routing protocol to filter outbound routes redistributed from the protocol.
Follow these steps to configure a RIPng route filtering policy:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIPng view ripng [ process-id ] ––
Configure a filter policy to filter
incoming routes
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import Required
By default, RIPng does not filter
incoming routing information.
Configure a filter policy to filter
outgoing routes
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Required
By default, RIPng does not filter
outgoing routing information.
Configuring a priority for RIPng
Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value is, the higher the priority is.
Follow these steps to configure a RIPng priority:
To do… Use the command… Remarks
Enter system view system-view —
Enter RIPng view ripng [ process-id ] —
Configure a RIPng priority preference preference
Optional
By default, the RIPng priority is
100.
Configuring RIPng route redistribution
Follow these steps to configure RIPng route redistribution: