Configuring basic ipv6 functions, Enabling ipv6 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 120
109
Task Remarks
Configuring basic IPv6 functions
Required
Configuring an IPv6 global unicast
address
Required to configure one
Configuring an IPv6 link-local
address
Configure an IPv6 anycast address
Configuring a static neighbor entry
Optional
Configuring the maximum number
of neighbors dynamically learned
Optional
Configuring parameters related to
RA messages
Optional
Configuring the maximum number
of attempts to send an NS message
Optional
Optional
Configuring a static PMTU for a
specified IPv6 address
Optional
Configuring the aging time for
dynamic PMTUs
Optional
Configuring IPv6 TCP properties
Optional
Configuring IPv6 FIB load sharing
Optional
Configuring ICMPv6 packet
sending
Configuring the maximum ICMPv6
error packets sent in an interval
Optional
Enabling replying to multicast echo
requests
Optional
Enabling sending of ICMPv6 time
exceeded messages
Optional
Enabling sending of ICMPv6
destination unreachable messages
Optional
Configuring basic IPv6 functions
Enabling IPv6
Enable IPv6 before you perform any IPv6-related configuration. Without IPv6 enabled, an interface
cannot forward IPv6 packets even if it has an IPv6 address configured.
Follow these steps to enable IPv6:
To do...
Use the command...
Remarks
Enter system view
system-view
—
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points