Configuring pmtu discovery, Configuring the aging time for dynamic pmtus, Configuring ipv6 tcp properties – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 129

118
To do…
Use the command…
Remarks
Enter Ethernet interface
view/aggregate interface view
interface interface-type
interface-number
—
Configure the maximum number of
ND snooping entries the interface
can learn
ipv6 nd snooping
max-learning-num number
Optional
By default, the number of ND
snooping entries an interface can
learn is unlimited.
Configuring PMTU discovery
Configuring a static PMTU for a specified IPv6 address
You can configure a static PMTU for a specified destination IPv6 address. When a source host sends a
packet through an interface, it compares the interface MTU with the static PMTU of the specified
destination IPv6 address. If the packet size is larger than the smaller one of the two values, the host
fragments the packet according to the smaller value.
Follow these steps to configure a static PMTU for a specified IPv6 address:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure a static PMTU for a
specified IPv6 address
ipv6 pathmtu ipv6-address
[ value ]
Required
Not configured by default.
Configuring the aging time for dynamic PMTUs
After the path MTU from a source host to a destination host is dynamically determined (see “
“), the source host sends subsequent packets to the destination host based on this MTU. After
the aging time expires, the dynamic PMTU is removed and the source host re-determines a dynamic path
MTU through the PMTU mechanism.
The aging time is invalid for a static PMTU.
Follow these steps to configure the aging time for dynamic PMTUs:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the aging time for
dynamic PMTUs
ipv6 pathmtu age age-time
Optional
10 minutes by default.
Configuring IPv6 TCP properties
You can configure the following IPv6 TCP properties.
•
synwait timer: When a SYN packet is sent, the synwait timer is triggered. If no response packet is
received before the synwait timer expires, the IPv6 TCP connection establishment fails.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points