H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 147)

136
NOTE:
•
When configuring a static route, the static route does not take effect if you specify the next hop address
first and then configure it as the IP address of a local interface, such as VLAN interface.
• If you do not specify the preference when configuring a static route, the default preference will be used.
Reconfiguring the default preference applies only to newly created static routes.
• If the destination IP address and mask are both configured as 0.0.0.0 with the ip route-static command,
the route is the default route.
• For detailed information about track, see the High Availability Configuration Guide.
Displaying and maintaining static routes
To do… Use the command… Remarks
Display information of static routes
display ip routing-table protocol static [ inactive |
verbose ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view
Delete all the static routes delete static-routes all
Available in
system view
NOTE:
For more information about the display ip routing-table protocol static [ inactive | verbose ] [ | { begin
| exclude | include } regular-expression ] command, see the Layer 3 Command Reference.
Static route configuration examples
Basic static route configuration example
Network requirements
The IP addresses and masks of the switches and hosts are shown in Figure 50 . Static routes are required
for interconnection between any two hosts.