H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 179)

168
Task Remarks
Tuning and optimizing the RIPng
network
Configuring RIPng timers Optional
Configuring split horizon and poison reverse Optional
Configuring zero field check on RIPng packets Optional
Configuring the maximum number of equal
cost routes for load balancing
Optional
Configuring RIPng basic functions
This section presents the information to configure the basic RIPng features.
You need to enable RIPng first before configuring other tasks, but it is not necessary for RIPng related
interface configurations, such as assigning an IPv6 address.
Configuration prerequisites
Before the configuration, complete the following tasks first:
• Enable IPv6 packet forwarding.
• Configure an IP address for each interface, and make sure all nodes are reachable to one another.
Configuration procedure
Follow these steps to configure the basic RIPng functions:
To do… Use the command… Remarks
Enter system view system-view ––
Create a RIPng process and enter
RIPng view
ripng [ process-id ]
Required
Not created by default
Return to system view quit —
Enter interface view
interface interface-type
interface-number
––
Enable RIPng on the interface ripng process-id enable
Required
Disabled by default
NOTE:
If RIPng is not enabled on an interface, the interface will not send or receive any RIPng route.
Configuring RIPng route control
This section covers the following topics:
• Configuring RIPng route summarization
• Advertising a default route