H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 184)

173
Configuring the maximum number of equal cost routes for load
balancing
Follow these steps to configure the maximum number of equal cost RIPng routes for load balancing:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIPng view ripng [ process-id ] ––
Configure the maximum number of
equal cost RIPng routes for load
balancing
maximum load-balancing number
Optional
6 by default
Displaying and maintaining RIPng
To do… Use the command… Remarks
Display configuration information
of a RIPng process
display ripng [ process-id ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display routes in the RIPng
database
display ripng process-id database
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display the routing information of
a specified RIPng process
display ripng process-id route [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display RIPng interface information
display ripng process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Reset a RIPng process reset ripng process-id process Available in user view
Clear statistics of a RIPng process reset ripng process-id statistics Available in user view
RIPng configuration examples
Configure RIPng basic functions
Network requirements
As shown in Figure 61 , all switches run RIPng. Configure Switch B to filter the route (3::/64) learned from
Switch C, which means the route will not be added to the routing table of Switch B, and Switch B will not
forward it to Switch A.