H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 71)

63
System starts booting …
3. Set a new password in system view.
system-view
[H3C]user-interface aux 0
[H3C-ui-aux0]authentication-mode password
[H3C-ui-aux0]set authentication password simple 123456
The output shows that password authentication is required for console port login, and the password has
been set to 123456 in plain text.
NOTE:
•
Upon reboot, the system runs with the default configuration, with the configuration file stored in the Flash
memory. To restore the original configuration, use the display saved-configuration command to view
the contents of the configuration file, copy them and run them.
• If the password is stored in plain text, use the display current-configuration command to view the
password in the current configuration. If you use the set authentication password cipher 123456
command to set your password, the password will be stored in cipher text.
4. Save the new configuration.
[H3C] save
NOTE:
After modifying the user password, use the save command to save it.
Super password loss
The super password allows you to switch between four super levels. Without a super password, you
cannot perform higher privilege operations.
Select 8 from the BootWare main menu to clear the super password.
NOTE:
•
After selecting 8 and restarting the switch, you will directly enter system view.
• This setting works only once. When the switch is restarted for a second time, the super password is
restored.
Backing up and restoring BootWare
Backing up and restoring BootWare through the BootWare
menu
Select 7 from the BootWare main menu to enter the BootWare operation submenu. For more information
about this submenu, see “ BootWare operation submenu .”
Backing up BootWare
To back up the entire BootWare to the Flash memory, select 1 from the BootWare main menu and follow
the instructions.