H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 28)

20
Figure 24 Connect fiber connectors
4. After powering on the switch, check the SFP port LEDs.
For more information about the SFP LEDs, see the chapter “Appendix A Technical specifications.”
WARNING!
When you connect a fiber, note the following guidelines:
• Never bend or curve a fiber with a fierce force. The bend radius of a fiber must be not less than 10 cm
(3.94 in).
• Make sure the TX and RX ports on a transceiver module are correctly connected.
• Keep the fiber end clean.
Installing/removing an interface card
NOTE:
The interface cards of the WX3024E are not hot swappable.
10-Gigabit small form-factor pluggable (XFP) interface cards are used for copper-to-fiber and
fiber-to-copper conversion in optical signal transmission. An XFP interface card requires fiber cables with
LC connectors.
Figure 25 Front panel
Installing an XFP interface card
To install an XFP interface card in an interface card slot: