H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 27)

19
Figure 22 Connect the console cable
NOTE:
If the switch has been powered on, connect the console cable to the PC before connecting to the switch,
and when you disconnect the cable, first disconnect from the switch.
Connecting the Ethernet cables
Connecting a copper Ethernet port
To connect a copper Ethernet port:
1. Connect one end of the Ethernet cable to the copper Ethernet port on the switch and the other end
to an Ethernet port of the peer switch.
2. After powering on the switch, check the LEDs of the fixed copper Ethernet port.
For more information about the LED description, see the chapter “Appendix A Technical
specifications.”
Connecting a fiber Ethernet port
To connect a 1000 Mbps fiber port:
1. Identify the top side of the SFP module, and gently insert it into the socket.
Figure 23 Insert a transceiver module
2. Identify the Rx and Tx ports on the transceiver module and plug the two LC connectors at one end
of the fibers into the Rx and Tx ports.
3. Plug the LC connectors at the other end of the fiber into the Tx and Rx ports on a fiber port on the
peer device.