H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 26)

18
5. Connect the other end of the RPS power cord to an output interface of the RPS.
Figure 21 Connect the switch to an RPS
(1) RPS power cord plug for the DC power receptacle (2) DC power receptacle
(3) AC power input interfaces of the RPS unit (4) DC output interfaces of the RPS unit
(5) RPS power cord (6) RPS power cord plug for the RPS output
(7) RPS
6. Check the RPS LED on the front panel of the switch. LED ON means the RPS unit is correctly
connected.
CAUTION:
Check that the grounding cable is properly connected before powering on the switch.
Connecting the interface cables
Connecting the console cable
1. Prepare a configuration terminal
The configuration terminal can be an ASCII terminal with an RS232 serial port or a PC. The
description in this section assumes that you use a PC as the configuration terminal.
2. Connect the console cable
a. Plug the DB-9 female connector of the console cable to the serial port of the PC.
b. Connect the RJ-45 connector to the console port of the switch.
NOTE:
Identify the mark on the console port and make sure that you are connecting to the correct port.