H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 34)

26
Powering on the switch
Verification before power-on
Before you power on the switch, verify that:
• The power cord and grounding cable are properly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is properly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
Boot process
Power on the switch, and you can see the following information:
System is starting...
Booting Normal Extend BootWare....
***************************************************************************
* *
* H3C WX3024E BootWare, Version 1.02 *
* *
***************************************************************************
Copyright (c) 2004-2010 Hangzhou H3C Technologies Co., Ltd.
Compiled Date : Nov 23 2010
CPU Type : XLS208
CPU L1 Cache : 32KB
CPU Clock Speed : 750MHz
Memory Type : DDR2 SDRAM
Memory Size : 512MB
Memory Speed : 533MHz
BootWare Size : 768KB
Flash Size : 1024MB
CPLD Version : 004
PCB Version : Ver.A
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Press Ctrl + B at the prompt within four seconds to access the Boot menu, or wait for the system to
automatically start up. To access the BootWare menu after the system software image files are
decompressed, you must restart the switch.
Starting to get the main application file--flash:/wx3000.bin!...........................
.............................................
The main application file is self-decompressing ........................................
.....................................................................................
.....................................................................................
.....................................................................................
.....................................................................................
.....................................................................................