H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 16)

8
Installing the switch
CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open the
chassis, contact your local HP agent for permission. Otherwise, H3C shall not be liable for any
consequence caused thereby.
Installing the switch in a 19-inch rack
The WX3024E switch can be installed in a standard 19-inch rack, and the installation falls into the
following scenarios:
• Installing the switch with front and rear mounting brackets.
• Installing the switch with front mounting brackets and a rack shelf.
• Installing the switch with front mounting brackets and slide rails.
NOTE:
•
The front mounting brackets can be used only for fixing the switch, rather than weight-bearing.
• The slide rails provided by H3C are suitable only for H3C standard racks with the depth of 1000 mm
(39.37 in). You need to seek other supporting means if your rack has a different depth.
Mounting brackets
Figure 4 Front mounting bracket
(1) Screw holes for fixing the front mounting bracket onto the rack (using M6 screws)
(2) Screw hole for fixing the front mounting bracket to the switch chassis
1
2