H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 63
55
•
For operations on the access control engine, the data needs to be transferred from the switching
engine to the access control engine, so you need to configure the IP addresses of the switching
engine, access control engine and the PC to be in the same network segment. For example,
configure the IP address of the TFTP server as 192.168.0.1, that of the access control engine of the
switch as 192.168.0.2, and that of the switching engine as 192.168.0.3 (to configure the IP address
of the switching engine, change to the CLI of the switching engine by using the oap command).
Verify the connection by using the ping command.
•
For operations on the switching engine, log in to the switching engine by using the oap command,
configure the IP addresses as mentioned above, and verify the connection by using the ping
command.
NOTE:
The IP addresses of the access control engine and switching engine are both configured in VLAN interface
view.
Backing up and restoring system software image files and configuration files
After setting up the environment, do the following on the terminal:
Use the dir command to check what files are in the file system:
Directory of flash:/
0 -rw- 1039 Jan 04 2011 17:21:52 startup.cfg
1 -rw- 35454328 Jan 18 2011 09:02:23 wx3000.bin
2 -rw- 4204 Jan 17 2011 15:43:25 system.xml
3 -rw- 2334 Jan 17 2011 15:43:26 test.cfg
1015424 KB total (979500 KB free)
For example, to copy the startup.cfg file on the switch and save it as config.bak on the TFTP server, use
the following command:
File will be transferred in binary mode
Sending file to remote TFTP server. Please wait... \
TFTP: 1039 bytes sent in 0 second(s).
File uploaded successfully.
To download config.cfg from the server to the switch, use the following command:
The file statup.cfg exists. Overwrite it?[Y/N]:y
Verifying server file...
Deleting the old file, please wait...
File will be transferred in binary mode
Downloading file from remote tftp server, please wait...\
TFTP: 1039 bytes received in 0 second(s)
File downloaded successfully.
If a file with the same name exists on the switch, the switch will prompt you whether to overwrite the
existing file. You can choose Y to overwrite it or N to abort.