H3C Technologies H3C SR8800 - Manual (Page 68)

60
Configuring frame relay subinterface
See “ Configuring frame relay subinterface .”
Enabling the trap function
With the trap function enabled for frame relay, notifications traps are generated for notifying critical
events that occur to frame relay. Thus, when events that should be notified occur to frame relay, traps will
be sent to the information center. You can configure the information center to output the trap information
matches certain criteria to a desired destination (the console for example) for analysis.
To enable the trap function for the frame relay module:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable trap for the frame relay
module.
snmp-agent trap enable fr
Optional.
By default, trap is enabled for the
frame relay module.
NOTE:
•
For more information about the snmp-agent trap enable fr command, see Network Management and
Monitoring Command Reference.
• For how to configure the information center, see Network Management and Monitoring Configuration
Guide.
Displaying and maintaining frame relay
Task Command Remarks
Display frame relay protocol
status on an interface.
display fr interface [ interface-type
{ interface-number |
interface-number.subnumber } ] [ | { begin
| exclude | include } regular-expression ]
Available in any view
Display the mapping table of
protocol address and frame
relay address.
display fr map-info [ interface
interface-type { interface-number |
interface-number.subnumber } ] [ | { begin
| exclude | include } regular-expression ]
Available in any view
Display receiving/sending
statistics of frame relay LMI type
messages. display fr lmi-info [ interface interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display incoming and outgoing
frame relay data statistics.
display fr statistics [ interface
interface-type interface-number ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view