H3C Technologies H3C SR8800 - Manual (Page 56)

48
Step Command Remarks
10. Enable the HDLC link bundle
interface.
undo shutdown
Optional.
Enabled by default.
Enabling/disabling an HDLC link
bundle interface does not enable or
disable any member interface in
the HDLC link bundle but may
affect the selected states of the
member interfaces.
CAUTION:
•
The number of selected member interfaces required to bring up an HDLC link bundle should be no
bigger than the limit on the number of selected member interfaces in the HDLC link bundle.
• To guarantee normal traffic transmission, on the HDLC link bundle interfaces on both ends of an HDLC
link bundle, configure the same parameters, including the number of selected member interfaces
required to bring up the HDLC link bundle, limit on the number of selected member interfaces in the
HDLC link bundle, and minimum amount of bandwidth required to bring up the HDLC link bundle.
• For more information about the ip address command, see Layer 3—IP Services Command Reference.
Assigning an interface to an HDLC link bundle
To assign an interface to an HDLC link bundle:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter POS interface view or
serial interface view. interface interface-type
interface-number
N/A
3. Set the link layer protocol of
the interface to HDLC.
link-protocol hdlc PPP by default.
4. Assign the interface to an
HDLC link bundle.
bundle id bundle-id N/A
5. Set the bundling priority for
the member interface.
bundle member-priority priority
Optional.
32768 by default.