H3C Technologies H3C SR8800 - Manual (Page 21)

13
[RouterC-Atm3/1/1] pvc to_a 0/60
[RouterC-atm-pvc-Atm3/1/1-0/60-to_a] map ip 202.38.160.1 broadcast
[RouterC-atm-pvc-Atm3/1/1-0/60-to_a] quit
[RouterC-Atm3/1/1] pvc to_b 0/61
[RouterC-atm-pvc-Atm3/1/1-0/61-to_b] map ip 202.38.160.2 broadcast
IPoEoA configuration example
Network requirements
As shown in Figure 5 , Router A, B, and C are connected to an ATM network. The IP addresses of their
Layer 3 VE interfaces are 202.38.160.1/24, 202.38.160.2/24, and 202.38.160.3/24 respectively.
In the ATM network, the VPI/VCI pairs for the PVCs to Router B and Router C are 0/40 and 0/41 on
Router A; the VPI/VCI pairs for the PVCs to Router A and Router C are 0/50 and 0/51 on Router B; and
the VPI/VCI pairs for the PVCs to Router A and Router B on are 0/60 and 0/61 on Router C.
Configure IPoEoA encapsulation on all the PVCs on the ATM interfaces of the three routers.
Figure 5 Network diagram
Configuration procedure
1. Configure Router A:
# Create a Layer 3 VE interface and configure an IP address for it.
system-view
[RouterA] interface Virtual-Ethernet 3/0/1
[RouterA-Virtual-Ethernet3/0/1] ip address 202.38.160.1 255.255.255.0
[RouterA-Virtual-Ethernet3/0/1] quit
# Create a PVC and enable IPoEoA on it.
[RouterA] interface Atm 3/1/1
[RouterA-Atm3/1/1] pvc to_b 0/40
[RouterA-atm-pvc-Atm3/1/1-0/40-to_b] map bridge Virtual-Ethernet 3/0/1
[RouterA-atm-pvc-Atm3/1/1-0/40-to_b] quit
[RouterA-Atm3/1/1] pvc to_c 0/41
[RouterA-atm-pvc-Atm3/1/1-0/41-to_c] map bridge Virtual-Ethernet 3/0/1