H3C Technologies H3C SR8800 User Manual
Page 42
34
[RouterA] domain system
[RouterA-isp-system] authentication ppp local
2.
Configure Router B:
# Enable PPP encapsulation on interface Serial 4/1/9/1:0.
[RouterB] interface Serial 4/1/9/1:0
[RouterB-Serial4/1/9/1:0] link-protocol ppp
# Configure the PAP username and password sent from Router B to Router A when Router B is
authenticated by Router A by using PAP.
[RouterB-Serial4/1/9/1:0] ppp pap local-user userb password simple passb
# Assign an IP address to Serial 4/1/9/1:0 of Router B.
[RouterB-Serial4/1/9/1:0] ip address 200.1.1.2 16
3.
Verify the configuration:
Use the display interface command to display information about Serial 4/1/9/1:0 of Router B.
The physical layer status and link layer status of the interface are both up, and the states of LCP and
IPCP are both Opened, indicating that PPP negotiation is successful. Router A and Router B can
ping each other.
[RouterB-Serial4/1/9/1:0] display interface Serial 4/1/9/1:0
Serial4/1/9/1:0 current state: UP
Line protocol current state: UP
Description: Serial4/1/9/1:0 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 200.1.1.2/16 Primary
Link layer protocol is PPP
LCP opened, IPCP opened
CRC type is 16-bit
Last 300 seconds input: 0 packets/sec, 3 bytes/sec
Last 300 seconds output: 0 packets/sec, 2 bytes/sec
Input(total): 367 packets, 13212 bytes
Input(Bad): 0 Abort, 0 FCS-Error, 0 FIFO-Abort, 0 Giant, 0 Runt
Output(total): 654 packets, 9156 bytes
Output(Bad): 0 Abort
Peak value of input: 3 bytes/sec, at 2010-11-04 17:02:07
Peak value of output: 2 bytes/sec, at 2010-11-04 17:02:07
[RouterB-Serial4/1/9/1:0] ping 200.1.1.1
PING 200.1.1.1: 56 data bytes, press CTRL_C to break
Reply from 200.1.1.1: bytes=56 Sequence=1 ttl=255 time=103 ms
Reply from 200.1.1.1: bytes=56 Sequence=2 ttl=255 time=1 ms
Reply from 200.1.1.1: bytes=56 Sequence=3 ttl=255 time=1 ms
Reply from 200.1.1.1: bytes=56 Sequence=4 ttl=255 time=1 ms
Reply from 200.1.1.1: bytes=56 Sequence=5 ttl=255 time=10 ms
--- 200.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
- H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module