H3C Technologies H3C S5560 Series Switches - Manual (Page 93)

77
Step Command Remarks
7. Specify a neighbor and its
router priority. peer ip-address [ dr-priority
dr-priority ]
By default, no neighbor is specified.
The priority configured with this
command indicates whether a
neighbor has the election right or not. If
you configure the router priority for a
neighbor as 0, the local router
determines the neighbor has no
election right, and does not send hello
packets to this neighbor. However, if
the local router is the DR or BDR, it still
sends hello packets to the neighbor for
neighbor relationship establishment.
Configuring the P2MP network type for an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the OSPF network
type for the interface as
P2MP.
ospf network-type p2mp [ unicast ]
By default, the network type of an
interface depends on the link layer
protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are unicast
over the interface. The interface
cannot broadcast hello packets to
discover neighbors, so you must
manually specify the neighbors.
4. Return to system view. quit N/A
5. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
6. (Optional.) Specify a
neighbor and its router
priority.
peer ip-address [ cost value ]
By default, no neighbor is specified.
This step must be performed if the
network type is P2MP unicast, and is
optional if the network type is P2MP.
Configuring the P2P network type for an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A