Ospfv3 dr election configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual
Page 409
393
*Destination: 1234::/64
Type : E2 Cost : 1
NextHop : FE80::20C:29FF:FEB9:F2EF Interface: Vlan400
AdvRouter : 2.2.2.2 Area : 0.0.0.2
Preference : 10
Total: 4
Intra area: 1 Inter area: 2 ASE: 1 NSSA: 0
The output shows an AS external route imported from the NSSA area exists on Switch D.
OSPFv3 DR election configuration example
Network requirements
As shown in
:
•
Configure router priority 100 for Switch A, the highest priority on the network, so it will become the
DR.
•
Configure router priority 2 for Switch C, the second highest priority on the network, so it will
become the BDR.
•
Configure router priority 0 for Switch B, so it cannot become a DR or BDR.
•
Switch D uses the default router priority 1.
Figure 90 Network diagram
Configuration procedure
1.
Configure IPv6 addresses for interfaces. (Details not shown.)
2.
Configure basic OSPFv3:
# On Switch A, enable OSPFv3 and specify the router ID as 1.1.1.1.
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ospfv3 1 area 0
[SwitchA-Vlan-interface100] quit