Verifying the configuration – H3C Technologies H3C S5560 Series Switches User Manual

Page 142

126

[SwitchB-ospf-1] quit

# Configure Switch C.

system-view

[SwitchC] ospf

[SwitchC-ospf-1] area 0

[SwitchC-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255

[SwitchC-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255

[SwitchC-ospf-1-area-0.0.0.0] quit

[SwitchC-ospf-1] quit

Configure BFD:
# Enable BFD on Switch A and configure BFD parameters.

[SwitchA] bfd session init-mode active

[SwitchA] interface vlan-interface 10

[SwitchA-Vlan-interface10] ospf bfd enable

[SwitchA-Vlan-interface10] bfd min-transmit-interval 500

[SwitchA-Vlan-interface10] bfd min-receive-interval 500

[SwitchA-Vlan-interface10] bfd detect-multiplier 7

[SwitchA-Vlan-interface10] quit

[SwitchA] quit

# Enable BFD on Switch B and configure BFD parameters.

[SwitchB] bfd session init-mode active

[SwitchB] interface vlan-interface 10

[SwitchB-Vlan-interface10] ospf bfd enable

[SwitchB-Vlan-interface10] bfd min-transmit-interval 500

[SwitchB-Vlan-interface10] bfd min-receive-interval 500

[SwitchB-Vlan-interface10] bfd detect-multiplier 6

Verifying the configuration

# Display the BFD information on Switch A.

display bfd session

Total Session Num: 1 Up Session Num: 1 Init Mode: Active

IPv4 Session Working Under Ctrl Mode:

LD/RD SourceAddr DestAddr State Holdtime Interface

3/1 192.168.0.102 192.168.0.100 Up 1700ms Vlan10

# Display routes destined for 120.1.1.1/32 on Switch A.

display ip routing-table 120.1.1.0 verbose

Summary Count : 1

Destination: 120.1.1.0/24

Protocol: OSPF Process ID: 1

SubProtID: 0x1 Age: 04h20m37s

Cost: 2 Preference: 10

Tag: 0 State: Active Adv

This manual is related to the following products: