H3C Technologies H3C S5560 Series Switches - Manual (Page 452)

436
Configuring if-match clauses
You can either specify no if-match clauses or multiple if-match clauses for a routing policy node. If no
if-match clauses are specified for a permit-mode node, all routes can pass the node. If no if-match
clauses are specified for a deny-mode node, no routes can pass the node.
The if-match clauses of a routing policy node have a logical AND relationship. A route must meet all
if-match clauses before it can be executed by the apply clauses of the node. If an if-match command
exceeds the maximum length, multiple identical if-match clauses are generated. These clauses have a
logical OR relationship. A route only needs to match one of them.
To configure if-match clauses:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter routing policy node view. route-policy route-policy-name { deny
| permit } node node-number
N/A
3. Match routes whose destination,
next hop, or source matches an
ACL or prefix list.
• Match IPv4 routes whose
destination, next hop, or source
matches an ACL or IPv4 prefix list:
if-match ip { address | next-hop |
route-source } { acl acl-number |
prefix-list prefix-list-name }
• Match IPv6 routes whose
destination, next hop, or source
matches an ACL or IPv6 prefix list:
if-match ipv6 { address |
next-hop | route-source } { acl
acl6-number | prefix-list
prefix-list-name }
By default, no ACL or prefix
list match criterion is
configured.
If the ACL used by an if-match
clause does not exist, the
clause is always matched. If
no rules of the specified ACL
are matched or the match
rules are inactive, the clause
is not matched.
The ACL specified in an
if-match clause must be a
non-VPN ACL.
4. Match BGP routes whose
AS_PATH attribute matches a
specified AS path list.
if-match as-path
as-path-number&<1-32> By default, no AS path match
criterion is configured.
5. Match BGP routes whose
COMMUNITY attribute matches
a specified community list.
if-match community
{ { basic-community-list-number |
name comm-list-name }
[ whole-match ] |
adv-community-list-number }&<1-32>
By default, no COMMUNITY
match criterion is matched.
6. Match routes having the
specified cost.
if-match cost value
By default, no cost match
criterion is configured.
7. Match BGP routes whose
extended community attribute
matches a specified extended
community list.
if-match extcommunity
ext-comm-list-number&<1-32>
By default, no extended
community list match criterion
is configured.
8. Match routes having the
specified output interface. if-match interface { interface-type
interface-number }&<1-16>
By default, no output interface
match criterion is configured.
This command is not
supported by BGP.