H3C Technologies H3C S5560 Series Switches - Manual (Page 443)

427
Displaying and maintaining IPv6 PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display IPv6 PBR policy information. display ipv6 policy-based-route [ policy policy-name ]
Display IPv6 PBR configuration. display ipv6 policy-based-route setup
Display IPv6 local PBR configuration and
statistics.
display ipv6 policy-based-route local [ slot slot-number ]
Display IPv6 interface PBR configuration and
statistics. display ipv6 policy-based-route interface interface-type
interface-number [ slot slot-number ]
Clear IPv6 PBR statistics. reset ipv6 policy-based-route statistics [ policy policy-name ]
IPv6 PBR configuration examples
Packet type-based IPv6 local PBR configuration example
Network requirements
As shown in Figure 99 , configure IPv6 PBR on Switch A to forward all TCP packets to the next hop 1::2.
Switch A forwards other packets according to the routing table.
Figure 99 Network diagram
Configuration procedure
1. Configure Switch A:
# Create VLAN 10 and VLAN 20.
system-view
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] vlan 20
[SwitchA-vlan20] quit
# Configure the IPv6 addresses of VLAN-interface 10 and VLAN-interface 20.
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ipv6 address 1::1 64
[SwitchA-Vlan-interface10] quit
[SwitchA] interface vlan-interface 20
[SwitchA-Vlan-interface20] ipv6 address 2::1 64