H3C Technologies H3C S5560 Series Switches - Manual (Page 313)

297
[SwitchB-bgp] address-family ipv4
[SwitchB-bgp-ipv4] network 200.1.1.0 24
[SwitchB-bgp-ipv4] network 9.1.1.0 24
# Enable Switch B to exchange IPv4 unicast routing information with Switch A and Switch C.
[SwitchB-bgp-ipv4] peer 200.1.1.2 enable
[SwitchB-bgp-ipv4] peer 9.1.1.2 enable
3. Configure Switch C:
# Configure IP addresses for interfaces. (Details not shown.)
# Configure the IBGP connection.
system-view
[SwitchC] bgp 65009
[SwitchC-bgp] router-id 3.3.3.3
[SwitchC-bgp] peer 9.1.1.1 as-number 65009
# Enable GR capability for BGP.
[SwitchC-bgp] graceful-restart
# Enable Switch C to exchange IPv4 unicast routing information with Switch B.
[SwitchC-bgp-ipv4] peer 9.1.1.1 enable
Verifying the configuration
Ping Switch C on Switch A. Meanwhile, perform an active/standby switchover on Switch B. The ping
operation is successful during the whole switchover process.
BFD for BGP configuration example
Network requirements
As shown in Figure 72 , configure OSPF as the IGP in AS 200.
• Establish two IBGP connections between Switch A and Switch C. When both paths operate
correctly, Switch C uses the path Switch A<—>Switch B<—>Switch C to exchange packets with
network 1.1.1.0/24.
• Configure BFD over the path. When the path fails, BFD can quickly detect the failure and notify it
to BGP. Then, the path Switch A<—>Switch D<—>Switch C takes effect immediately.