H3C Technologies H3C S5560 Series Switches - Manual (Page 172)

156
Configuring IS-IS network management
This task includes the following configurations:
• Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
• Enable IS-IS notifications to report important events.
Notifications are delivered to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
To configure IS-IS network management:
Step Command Remarks
1. Enter system view. system-view N/A
2. Bind MIB to an IS-IS
process.
isis mib-binding process-id
By default, MIB is bound to the IS-IS
process with the smallest process
ID.
3. Enable IS-IS
notification sending.
snmp-agent trap enable isis
[ adjacency-state-change | area-mismatch
| authentication | authentication-type |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-corrupt |
lsp-parse-error | lsp-size-exceeded |
manual-address-drop | max-seq-exceeded
| maxarea-mismatch | own-lsp-purge |
protocol-support | rejected-adjacency |
skip-sequence-number | version-skew ] *
By default, IS-IS notification
sending is enabled.
4. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
5. Configure the context
name for the SNMP
object for managing
IS-IS.
snmp context-name context-name
By default, no context name is set
for the SNMP object for managing
IS-IS.
Enhancing IS-IS network security
To enhance the security of an IS-IS network, you can configure IS-IS authentication. IS-IS authentication
involves neighbor relationship authentication, area authentication, and routing domain authentication.
Configuration prerequisites
Before the configuration, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
• Enable IS-IS.