H3C Technologies H3C S5560 Series Switches - Manual (Page 402)

386
Purpose Command
Display OSPFv3 request list
information. display ospfv3 [ process-id ] [ area area-id ] request-queue
[ interface-type interface-number ] [ neighbor-id ]
Display OSPFv3 retransmission list
information. display ospfv3 [ process-id ] [ area area-id ] retrans-queue
[ interface-type interface-number ] [ neighbor-id ]
Display OSPFv3 routing information. display ospfv3 [ process-id ] routing [ ipv6-address prefix-length ]
Display OSPFv3 topology information. display ospfv3 [ process-id ] [ area area-id ] spf-tree [ verbose ]
Display OSPFv3 statistics. display ospfv3 [ process-id ] statistics [ error ]
Display OSPFv3 virtual link
information.
display ospfv3 [ process-id ] vlink
Restart an OSPFv3 process. reset ospfv3 [ process-id ] process [ graceful-restart ]
Restart OSPFv3 route redistribution. reset ospfv3 [ process-id ] redistribution
Clear OSPFv3 statistics. reset ospfv3 [ process-id ] statistics
OSPFv3 configuration examples
OSPFv3 stub area configuration example
Network requirements
As shown in Figure 88 :
• Enable OSPFv3 on all switches.
• Split the AS into three areas.
• Configure Switch B and Switch C as ABRs to forward routing information between areas.
• Configure Area 2 as a stub area to reduce LSAs in the area without affecting route reachability.
Figure 88 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# On Switch A, enable OSPFv3 and specify the router ID as 1.1.1.1.