Amer Networks WLO220T CLI - Manual (Page 95)

C O M M A N D D E S C R I P T I O N S
vrouter
2
92 CLI Reference Guide
Keywords and Variables
rip
set vrouter default
rip
To enable RIP, use the following commands, starting in global configuration mode.
To enable a RIP routing process:
set vrouter rip enable
To associate a network router-id with a RIP routing process:
set vrouter-id number
To disable RIP instance:
unset vrouter rip
Enabling RIP on Interfaces
By default, RIP is disabled on all interfaces and you must explicitly enable it on an interface. When
you disable RIP at the interface level, RIP does not transmit or receive packets on the specified
interface. Interface configuration parameters are preserved when you disable RIP on an interface.
To enable RIP on interface:
set interface name protocol rip enable
To disable RIP on interface:
unset interface name protocol rip
Global RIP Configuration Parameters
RIP Interface Configuration parameters
set protocol rip flush-timer number Specifies in seconds when a route is to be removed from the
time the route is invalidated. Default: 120 secs.
set protocol rip advertise-def-route
{always} {number} Specifies whether default route (0.0.0.0/0) is advertised. If
user specifies ‘always’ they must specify ‘number’ (metric).
Default: none. Default: Disabled.
set protocol rip reject-def-route Specifies whether default route learned from another
protocol is to be rejected. Default: Disabled.
set interface name protocol rip
split-horizon Specifies whether to enable split-horizon (do not advertise
routes learned from an interface in updates sent to the same
interface). Default: none
set interface name protocol rip
authentication mode [text | md5
]
Specifies either clear text password or MD5 authentication.
Default: none