Amer Networks WLO220T CLI - Manual (Page 51)

C O M M A N D D E S C R I P T I O N S
log
2
48 CLI Reference Guide
Keywords and Variables
destination
set log module name_str level string destination string
unset log module name_str level string destination string
destination
Specifies the destination of the generated log messages. The permissible destinations are
console, internal, email, ssh, and syslog.
Example
The following command instructs the device to direct all system module messages at the alert
level to the console port.
set log module system level alert destination console
unset unset log module
{
arp level [*] destination [**] |
cfg level [*] destination [**] |
dhclient level [*] destination [**] |
dhcpserver level [*] destination [**] |
dhcrelay level [*] destination [**] |
dos level [*] destination [**] |
edk level [*] destination [**] |
fup level [*] destination [**] |
ike level [*] destination [**] |
interface level [*] destination [**] |
ip level [*] destination [**] |
ipsec level [*] destination [**] |
log level [*] destination [**] |
nat level [*] destination [**] |
policy level [*] destination [**] |
ppp level [*] destination [**] |
qos level [*] destination [**] |
reconn-deter level [*] destination [**] |
rib level [*] destination [**] |
rip level [*] destination [**] |
route level [*] destination [**] |
service level [*] destination [**] |
session level [*] destination [**] |
snmp level [*] destination [**]
srmmgr level [*] destination [**] |
system level [*] destination [**]
}
* = alert | all | critical | debugging | emergency | error |
information | notification | tracing | warning
** = console | e-mail | internal | ssh | syslog