Amer Networks WLO220T CLI - Manual (Page 54)

. . . . .
C O M M A N D D E S C R I P T I O N S
netflow
CLI Reference Guide 51
Example
The following command disallows the export of any flow if the non-exported received byte count
is less than 100 bytes.
set netflow match byte-range min 100
packet-range
set netflow match packet-range min min-packets
packet-range
The match criteria is based on the minimal packet count of the exported flow. If the non-
exported received packet count of a flow is less than the minimal value, it will not export it.
The valid value range is from 1 to (2^31 -1). The default is to ignore the packet-range.
Example
The following command disallows the export of any flow if its non-exported received packet count
is less than 5.
set netflow match packet-range min 5
incoming-interface
set netflow match incoming-interface interface-name
incoming-interface
The match criterion is based on the incoming interface. The default is to ignore the incoming
interface.
Example
The following command forces the software to export the flow only if its incoming interface is eth0.
set netflow match incoming-interface eth0
nexthop
set netflow match nexthop ip-address[netmask | /length]
nexthop
The match criteria is based on the next-hop IP address. The default is to ignore the nexthop.
Example
The following command forces the software to export the flow only if its nexthop is 10.1.1.255.
set netflow. match nexthop 10.1.1.255
outgoing-interface
set netflow match outgoing-interface interface-name