beautypg.com

Netflow, Syntax keywords and variables – Amer Networks WLO220T CLI User Manual

Page 53

background image

C O M M A N D D E S C R I P T I O N S

netflow

2

50

CLI Reference Guide

netflow

The netflow commands are used to collect, filter, and aggregate data packets. The results are sent
based on the Netflow protocol.

Syntax

Keywords and Variables

byte-range

set netflow match byte-range min min-byte-num

byte-range

The match criterion is based on the minimal byte count of the exported flow. If the non-
exported received byte count of a flow is less than the minimal value, the flow is not exported.
The valid value range is from 1 to (2^31 -1). The default value is 1.

get

get netflow

set

set netflow collector IP-address port port

set netflow bandwidth k-bytes-per-second

set netflow enable

set netflow sampling algorithm algo-name

set netflow sampling interval mili-second

set netflow match byte-range min min-byte-num

set netflow match packet-range min min-packets

set netflow match incoming-interface interface-name

set netflow match nexthop

{

ip-address [netmask | ip-address | nn]

}

set netflow match outgoing-interface interface-name

set netflow match tos

{

tos-byte tosbyte-value| dscp dscp-value

}

unset

unset dpi signature signature-name

unset netflow collector

unset netflow bandwidth

unset netflow enable

unset netflow sampling interval

unset netflow match

{

bytes-range | packet-range | incoming-interface |nexthop |
outgoing-interface | tos

}

This manual is related to the following products: