Amer Networks WLO220T CLI - Manual (Page 49)

C O M M A N D D E S C R I P T I O N S
log
2
46 CLI Reference Guide
log
Use the log commands to configure the device for message logging. The log commands allow
you to perform the following:
• Display the current log status according to severity level, policy, service, software module, source,
destination, or duration.
• Determine which log information to display or omit.
• Configure logging to mitigate message loss due to memory limitations.
Syntax
get get log
{
message |
setting [ module
{
arp
cfg
dhclient
dhcpserver
dhcrelay
dos
edk
fup
ike
interface
ip
ipsec
log
nat
policy
ppp
qos
reconn-deter
rib
rip
route
service
session
snmp
srmmgr
system
} ]
}