Amer Networks WLO220T CLI - Manual (Page 84)

. . . . .
C O M M A N D D E S C R I P T I O N S
syslog
CLI Reference Guide 81
enable
Enables the device to send messages to the syslog host(s).
facilities
set syslog config { hostname | ip_addr } facility
{
local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7
}
facilities
Defines the facility level for each syslog host that you specify.
Example
The following command sets the syslog host configuration to report all logs:
set syslog config 172.16.20.249 facility local0
log
set syslog config { hostname | ip_addr } log { all | event | traffic }
unset syslog config { hostname | ip_addr } log { all | event | traffic }
log
Directs the device to send traffic log entries, event log entries or both traffic and event log
entries to the syslog host.
port
set syslog config { hostname | ip_addr } port port_num
unset syslog config { hostname | ip_addr } port
port
Defines the port number on the syslog host that receives the User Datagram Protocol (UDP)
packets from the device.
Example
The following command changes the syslog port number to 911:
set syslog config { hostname | ip_addr } port 911
Defaults
This feature is disabled by default. The default syslog port number is 514.