Amer Networks WLO220T CLI - Manual (Page 100)

. . . . .
C O M M A N D D E S C R I P T I O N S
zone
CLI Reference Guide 97
dhcp-flood
Rate limit DHCP request packets. The threshold rate can be from 0-16777214 (per second).
Use the corresponding unset zone command to set an “unlimited” rate. Valid values are 1-
65535 per destination IP per second. The default is “unlimited”.
fin-flood.
Rate limit TCP FIN packets per dest IP. Use the corresponding unset zone command to set an
“unlimited” rate. The default setting is “unlimited”.
fin-no-ack
Drop TCP FIN packets without ACK flag. The default setting is on.
icmp-flood
Rate limit ICMP packets. Use the corresponding unset zone command to set an “unlimited”
rate. Valid values are 0-16777214. The default setting is “unlimited”.
icmp-frag
Drop ICMP packets that arrive fragmented. The default setting is on.
icmp-large
Drop ICMP packets larger than 1K. The default setting is on.
ip-bad-opt
Turns on the detection of IP packets with bad or malformed options. The default is on (so that
packets with such options will be dropped).
ip-filter-src
Drop packets with IP src routing options. The default setting is on.
ip-loose-src-route
Drop packets with IP loose src route. The default setting is on.
ip-record-route
Drop packets with IP record route option. The default setting is on.
ip-router-alert-opt
Drop packets with IP router alter option. The default setting is on.
ip-security-opt
Drop packets with IP security option. The default setting is on.
ip-stream-opt
Drop packets with IP stream ID option. The default setting is on.
ip-strict-src-route
Drop packets with IP strict src route. The default setting is on.
ip-timestamp-opt
Drop packets with IP timestamp options. The default setting is on.