Amer Networks WLO220T CLI - Manual (Page 55)

C O M M A N D D E S C R I P T I O N S
netflow
2
52 CLI Reference Guide
outgoing-interface
The match criterion is based on the outgoing interface. The default is to ignore the outgoing
interface.
Example
The following command forces the software to export the flow only if its outgoing interface is eth1.
set netflow match outgoing-interface eth1
TOS
set netflow match tos {tos-byte tosbyte| dscp }
TOS
The match criterion is based on the type-of-service (TOS). You can configure TOS by
specifying the TOS-byte or the DSCP value. The default is to ignore the TOS. The value range
for dscp is 0-63. The value range for TOS is 0-255.
Example
The following command forces the software to export the flow only if its dscp value is 24.
Set netflow match tos dscp 24