Amer Networks WLO220T CLI - Manual (Page 47)

C O M M A N D D E S C R I P T I O N S
interface
2
44 CLI Reference Guide
unset interface interface phy
phy
Defines the physical connection mode on the specified interface.
 link-down Forces the physical link down.
ppp
set interface interface ppp
unset interface interface ppp
Set/unset the interface as ppp.
route
set interface interface route
shift-from
In the following example you define DIP pool 10 on ethernet 0. This translates the 5 addresses
starting at 10.1.1.101 to 5 addresses starting at 2.1.10.11. It maintains a consistent relationship
between the two groups of addresses.
set interface eth0 dip 10 shift-from 10.1.1.101 to 2.1.10.11 2.1.10.15
This would map the addresses as follows:
10.1.1.101 2.1.10.11
10.1.1.102 2.1.10.12
10.1.1.103 2.1.10.13
10.1.1.104 2.1.10.14
10.1.1.105 2.1.10.15
transparent
set interface interface transparent
Sets transparent/bridge mode. For example:
set interface eth0 transparent
zone
set interface interface zone zone
zone
Binds the interface to specified security zone.
Example
The following command binds the interface eth1.1 to the “trust” zone:
set interface eth1.1 zone trust