Amer Networks WLO220T CLI - Manual (Page 40)

. . . . .
C O M M A N D D E S C R I P T I O N S
image
CLI Reference Guide 37
image
Use the image command to manage software images on the unit. After a software image is
downloaded onto the unit with the tftp command, the image command allows to set the
downloaded image as active. When invoking the image command the software image is
programmed into flash memory. The programming step can take between 5 and 10 minutes.
[NOTE] It is very important that during this programming step the unit remains powered and the
programming is not interrupted.
Syntax
Keywords and Variables
Variable Parameter
nextboot
Set next boot configuration.
pri/sec/default
Set primary/secondary/default location.
get get image
set set image
{
{nextboot} [ pri | sec | default ] }}