Welltech FXS SIP Gateway V.2.9 User Manual
Page 97
- 85 -
FXS Gateway Overview
flash -clean Clean the configuration stored.
Note:
This command will clean the configuration stored in
the flash and reboot it.
usr/config$
Figure 21-15 flash command list
Parameter Usages:
-clean: clean all the user defined value, and reboot Gateway in factory default mode.
Note:
It is recommanded that use [flash –clean] after application firmware id upgraded.
Warning:
User whose login name is root only executes it. All configurations in command
[ifaddr] and [pppoe] will be kept.
For example:
usr/config$ flash -clean
Flash clean start
Flash clean success!!
!! rebooting ...
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
HTTPD initialized...
Flash Check
WorkMode : PROXY_MODE
Start registering to Proxy server
AC4804[0] is ok
AC4804[1] is ok
successful 2 2