Welltech FXS SIP Gateway V.2.9 - Manual (Page 22)

- 10 -
FXS Gateway Overview
Click the “Local Area Connection” icon on the lower right hand side of your
desktop screen.
In the [Local Area Connection Status] windows, click the [Properties] button
the your Network windows will appear.
There is only one tab, [General], in the Network window.
Step 3. Click whether the TCP/IP Protocol has already been installed
onto your computer’s Ethernet card. Note that TCP/IP Protocol an
be installed for a computer’s Dial-Up Adapter as well as for the Ethernet
cad.
- If yes, go to set 7.
- If no, click the [Add] button
Step 4. Double-click [Protocol] in the Select Network Component Type or
highlight
[Protocol] then click [Add].
Step 5. Highlight [Microsoft] under the list of manufactures
Step 6. After a new second, you will be returned to the Network window. The TCP/IP
Protocol should now be on the list of installed network components.
Step 7. Click the [Properties] button. The TCP/IP Properties windows
consist of several tabs. Choose the [IP Address] tab.
Step 8. Select [Specify an IP Address] and enter [10.1.1.1] in the
[IP Address] location (where xxx is a number between 2 and 254 used by the
VoIP Gateway to identify each computer), and the default [Subnet Mask:
255.0.0.0]. Note than no two computers on the same LAN can have the same IP
address.
Step 9. Click on the [DNS Configuration] tab and select [Enable DNS]. Then click the
[Add] button.
Step 10. Click on the [Gateway] tab and enter the High-Performance VoIP Gateway
default gateway value 10.1.1.254 in the [new gateway] field, then
click [Add] Button.
Step 11. Click [OK] button, Restart your PC to complete the TCP/IP installation.
1.9 Power Up Your VoIP Gateway
At this point, you should have connected the console port, the LAN Port, the WAN
port and the power port to the appropriate devices or lines. Plug the power adapter into
a wall outlet. The Power LED should be on. The Status LED will come on after the
system tests are complete. The WAN LED and one of the LAN
LEDs come on immediately after the Status LED come on, if connections have
been made to the LAN and WAN ports.