Welltech FXS SIP Gateway V.2.9 - Manual (Page 83)

- 71 -
FXS Gateway Overview
Start registering to Proxy server
HTTPD initialized...
AC4804[0] is ok
AC4804[1] is ok
successful 2 2
Initialize OSS libraries...OK!
VP v1.42 stack open sucessfully.
login:
21.4.3 Peer-to-Peer Mode
Peer-to-Peer Mode allows users to call other VoIP devices without
the proxy server. When in Peer-To-Peer mode, FXS Gateway use Phone Book,
which will dial predefined phone number, and press “#” (optional, to accelerate the
dial) as end of dial.
To configure Peer-To-Peer Mode in FXS Gateway, follow the steps below:
To configure Peer-To-Peer Mode in Gateway, follow the steps below:
Step 1. Set Peer-To-Peer Mode, using “sip” command
usr/config$ sip –mode 0
Note:
mode 0 is for Peer-To-Peer mode, while mode 1 is for Proxy mode.
Step 2. Configure Phone Book, using “pbook” command.
Users can refer to chapter 19.7.9 [pbook] command for more information.
usr/config$ pbook –add name TEST1 ip 10.1.1.1 e164 10
Note:
The command is to add a record onto PhoneBook. After the
command completed, you can type “pbook –print” to see if the input record is
correct.
When adding a record to Phone Book, users do not have to
reboot the machine, and the record will be effective
immediately. For phonebook configuration, please refer to
Chapter 19.7.9.
21.4.4 Hotline Mode
The Hotline Mode is applied in limited two peers. User just picks up the phone set
and then hears ring back tone or dial tone depended on configurations of destination
device.